Hot water without the waste!
Have hot water at your fingertips whenever you turn the faucet. Stop wasting water as you wait for cold to turn to hot. Stop burning energy as you wait for warm to turn warmer. The Taco On Command System puts an end to the waste – and the wait – forever.
How On Command works…
The On Command™ is a small, silent pump attached to your hot and cold water lines in the cabinet under your most remote kitchen or bath fixture. When On Command™ is activated, the cool water you normally let run down the drain is circulated back to the water heater through the cold water line. Instantly the pump circulates hot water from the water heater, and returns the cooled water back through the cold water line. When the hot water arrives at the faucet, the On Command™ heat sensor and control board shut off the pump to prevent pumping excess hot water into the cold water line.
Activate On Command only when you need it.
On Command™ only runs when you tell it to, and it’s smart enough to know when the water currently in the line is hot enough. On Command™ can be activated with the push of a button, or with an optional wireless remote transmitter/ receiver or optional hard-wired motion sensor.
On Command is easy to install.
No new piping required. The On Command System not only saves water and energy, it saves in construction costs as well. No new return line is necessary; no need to drain the system; no demolition and repair. In fact, D’MAND System can be installed in just eight simple steps.
On Command. The best way to save.
On Command™ operates 24 hours a day to save you water, energy and money. What’s more, it’s made by Taco, known by plumbing professionals as a world leader in high quality hydronic components since 1920. The average home may waste over 12,000 gallons of water per year while waiting for hot water. Stop wasting and start saving with a Taco On Command™.